• Home
• Screen Layout
• Editor Pages
• Song Editor
• Chain Editor
• Pattern Editor
• Instrument Editor
• Drumkit Editor
• Envelope List Editor
• Table Editor
• Vibrato List Editor
• Duty Table Editor
• Echo List Editor
• Speed Table Editor
• MultiFX Editor
• Navigation Menu
• Setup/Utility Page
• Controls
• Commands
• Navigation
• Objects
• Requirements
• Quirks & Bugs
• NES Audio
• Glossary

Speed Table Editor Page

The Speed Table Editor shows one entire Speed Table. Speed Tables are similar to Grooves in LSDJ. However, because Pulsar/NES cannot run at arbitrary tempos as LSDJ can, Speed Tables not only control the 'groove' of your Song but also the playback speed.

You must specify the starting Speed Table for each Song in the Setup Page but you can also select a Speed Table within your Song by using the Speed Table command Gxx

As you can see, the Speed Table only has one column labelled SP - this is the number of ticks taken by each Pattern step.

Pulsar will step through the Speed Table until either the end (step 0F) or until an empty cell, '--'. At that point the Speed Table will start again at the beginning and continue looping.

If you just want a 'straight' speed then just set your desired speed in the first step of the Speed Table. If you want to create a 'groove' then you can specify multiple speeds (up to sixteen in one Speed Table). There are the same number of steps in a Speed Table as there is in a Pattern so that you could set the tick speed for the individual steps of an entire Pattern if you wanted to.

Note: Messing about with the values in a running Speed Table while the Song is playing can sometimes throw it out of sync (mostly when you have multiple speeds in a Speed Table). If that happens you can just restart your Song. Changing Speed Tables via Commands is fine though.

(c) Neil Baldwin, 2010